Business Card

Smooth International Group Limited

Smooth motion solutions, specialized in stepper motor, linear stepper motor, can-stack linear actuator in a wide and huge range series products since 1994, highly recognized as the leading manufacturer of linear motion solution.
Home   >  News

Choosing The Right Driver

2016-08-06


Choosing the right driver for your stepper motor is important because it will allow you to get the maximum amount of performance out of your motor.

Watch the amps

A critical thing to look for in a stepper motor driver is how many amps it is capable of sourcing. Some drivers list the maximum total number of amps while others list the maximum amperage per channel. So please be aware of that. Make sure that your stepper motor driver ratings meet or exceed the maximum amperage rating of your stepper motor so that you don’t leave any performance on the table. Finally, make sure that the driver allows you to adjust the number of amps it outputs so that you don’t damage your motor.


Bipolar or unipolar

If you’re making a CNC machine, you’ll almost certainly want to use a bipolar motor. You will need to make sure whatever driver you buy is designed to drive bipolar motors if that is indeed what you are using.

Microstepping

Normally, stepper motors have two modes, full step and half step. Most stepper motors in porpular have 200 full steps per revolution, or 400 half steps per revolution. But what if you want or need a higher resolution than that? Well, microstepping drivers may be for you! These circuits use a method to break each full step into fractional steps by using phasors. Basically, a microstepping driver may break down a full step into 64 very small steps. When using microstepping drivers, you should be aware that not all microsteps will be evenly spaced, so don’t depend on that too much. There is also approximately 30% less torque available to you. However, the major plus side is that microstepping can give you smooth motion at all speeds.


Where to buy stepper motor drivers

http://www.smoothmotor.com/driver-encoder.html  They’re cheap and good quality.


 

Message boardmin&max